SunSetter Replacement Fabric (Model 1100 and Others): Cost, Warranty and How to Swap It

Summarize with AI
Table of Contents
Expert-Designed Awnings, Built to Last
Follow Us
Illustration of a green striped SunSetter-style awning on a stucco wall with new fabric on the same frame and the old faded fabric rolled up below
Table of Contents
0:00
—:——
Press play to listen to this article

Yes, you can replace the fabric on a SunSetter awning without replacing the frame. You order new fabric from SunSetter for your exact model and width, crank the awning open, remove the front bar end plate, and slide the old fabric out of the roller bar and front bar slots while a helper feeds the new one in. Check your warranty first: on many SunSetters the fabric is free or discounted. If you would rather hire it out, Angi puts typical awning fabric replacement at $279 to $1,271.

Three ways to get new SunSetter fabric: claim it under warranty, order it and swap it yourself with a helper, or pay a pro (Angi typical range $279 to $1,271)

Is there a SunSetter Model 1100?

Lots of people search for “SunSetter Model 1100 replacement fabric”, and some online sellers list fabric under that name. But SunSetter’s own support library does not list a Model 1100 (checked 16 Nov 2026). It groups its awnings like this:

  • Platinum Series (Motorized, XL, PRO and Manual), Platinum Plus (semi-cassette) and Platinum Beyond
  • SunSetter Series Motorized, XL, PRO and Manual, plus SunSetter Essentials
  • Oasis freestanding awnings
  • Model 900XT / 1000XT and Model 900 / 1000

The series matters more than the nickname, because it decides which fabric lines fit, which warranty you have and which replacement steps you follow. If you are not sure what is on your wall, SunSetter’s support site has a “Not sure which model awning you own?” finder, or you can call SunSetter support at 1-800-670-7071 before you order anything.

Which SunSetter fabric should you order?

SunSetter sells four fabric lines in two series. Here is how they compare, based on SunSetter’s own descriptions:

Fabric line Series What it is Rain Fabric warranty
Sunbrella Platinum 100% acrylic Water-repellent 10-year limited
Performance Acrylic Platinum 100% solution-dyed acrylic, 98% UV protection Repels water 10-year limited
Woven Acrylic SunSetter Acrylic dyed at the fiber level Water-resistant 5-year limited
Laminated SunSetter Heavy-duty 5-layer fabric 100% waterproof 5-year limited

For most San Diego patios the choice comes down to shade versus rain. Laminated is the only line SunSetter calls waterproof, so it is the pick if light-rain cover matters to you. Even then, roll it in before heavy rain so water cannot pool. The acrylics shed water rather than block it, and the two Platinum fabrics, Sunbrella and Performance Acrylic, carry the longer 10-year warranty. Give SunSetter your exact model and width when you order, so the new fabric matches your roller bar and front bar.

Check your warranty before you pay for fabric

This is the step most owners skip, and it can make the fabric free. SunSetter’s warranties work very differently by series (checked 16 Nov 2026):

  • 10-year warranty (Platinum fabrics): covers fabric that becomes unusable from excessive loss of color or strength. Replacement fabric is 100% off in years 1 to 5, 50% off in years 6 to 8 and 25% off in years 9 and 10. Mold and mildew are not covered.
  • 5-year warranty (SunSetter Series, 900XT/1000XT and Oasis): covers excessive fading, mildew and excessive cracking or peeling. A defect reported within 12 months is replaced at no charge. After that you pay 1/60th of the retail price for each month of use before the claim.
  • Neither covers stretching or damage caused by wind or water pooling on the fabric, and both apply only to the original purchaser in the US. The 10-year warranty also excludes labor and freight, so ask what the 5-year terms include for yours.
Share of the fabric price you pay under SunSetter warranties by age: 10-year Platinum warranty 0% in years 1 to 5, 50% in years 6 to 8, 75% in years 9 to 10; 5-year warranty free in year 1 then 1/60th of retail per month of use, reaching 100% at 5 years

Replace or claim? Work out your SunSetter fabric options

Pick your awning, how old the fabric is and what is wrong with it. Nothing is sent anywhere.

How much does SunSetter replacement fabric cost?

SunSetter does not publish replacement fabric prices online. Its how-to guide says to call to order (1-800-876-2340), and its support site lists 1-800-670-7071 for orders. So the fabric price you will get depends on your model, width and fabric line.

For a full job with fabric and labor, Angi’s awning fabric replacement data (2025 figures, checked 16 Nov 2026) shows:

  • $769 average, with most people paying $279 to $1,271
  • $4 to $8 per square foot for material and installation
  • $50 to $120 an hour for labor

To make that useful for a SunSetter, we applied Angi’s square-foot rate to each width SunSetter lists for its Manual Awning, using SunSetter’s published projection for that width. Treat it as a rough budget, not a quote.

Rough installed cost of new fabric by SunSetter manual awning width at Angi rates of $4 to $8 per square foot: 8 ft wide $224 to $448; 10 ft wide $360 to $720; 12 ft wide $484 to $968; 14 ft wide $565 to $1,129; 16 ft wide $645 to $1,291; 18 ft wide $726 to $1,452

Want it done for you in San Diego County? If the fabric is torn, a seam has failed or you just do not want to work on a ladder, our awning repair service covers fabric replacement on retractable awnings. Tell us your SunSetter series and width and we will quote it.

How to replace SunSetter awning fabric, step by step

These steps follow SunSetter’s own instructions for its Platinum and SunSetter Series lateral arm awnings (Motorized, XL, PRO and Manual). Do not try it alone.

You need: a helper, a ladder, a Phillips screwdriver, the manual crank and safety glasses. Platinum Plus semi-cassette models also need a 6mm Allen wrench. SunSetter’s PDF opens with a warning that skipping safety glasses or the instructions “can result in personal injury”.

Top view of an open SunSetter awning: the fabric edges sit in a slot in the roller bar at the wall and a slot in the front bar. Remove the front bar end plate screws, slide the old fabric out of both slots at once, then feed the new fabric into both slots together.

  1. Open the awning fully. On a motorized model, set the remote or wall switch to neutral and unplug it. If there is an aluminum hood, remove the hood end plate on the side opposite the motor or gear.
  2. Crank out the rest of the fabric with the manual crank until you can see the fabric slot in the roller bar.
  3. Note which way the fabric faces, then remove the two screws (three on PRO models) from the front bar end plate.
  4. Pull the old fabric out of both bars at the same time. Your helper guides it while you slide it out to the side.
  5. Feed the new fabric into both slots together, facing the same way as the old one. Work in small steps, switching from one bar to the other, with your helper directing the edge into each slot. Center it on both bars.
  6. Refit the front bar end plate and the hood end plate if you have one.
  7. Roll it on slowly with the crank, keeping the fabric taut. It should roll over the top of the roller bar. Then plug in a motorized awning and test it.

Got a 900XT or 1000XT? Those models use a different method: you unbolt a rafter and bracket and support the roller bar while you work. Use SunSetter’s XT fabric replacement instructions instead of the steps above. For an Oasis, ask SunSetter support for the right sheet.

Call a pro rather than forcing it if the fabric will not slide, the arms do not close evenly when you roll it up, or the motor struggles after the swap. Those can mean a bent bar, an arm problem or a motor fault, which the repair team can look at.

Make new fabric last in San Diego

San Diego is easy on awning fabric in some ways and hard in others. NOAA’s climate study of San Diego counts an average of 146 clear days a year, and notes that most of the cloudy days come from the marine layer. So expect plenty of sun along with damp, gray marine-layer days. Here is what that means for the new fabric:

  • Keep it clean to keep mildew off. SunSetter’s warranty notes that mildew does not grow on the fabric itself but on dirt left on it. Sunbrella recommends hosing awning fabric off with clean water every month and a deeper clean every 2 to 3 years with a mild soap and a soft brush, then letting it air dry. Our canvas awning cleaning guide walks through it, or book awning cleaning.
  • Retract it when the wind picks up, including Santa Ana days. Both SunSetter warranties exclude stretching and damage caused by wind.
  • Roll it in before winter rain. Water pooling on the fabric is also excluded, and SunSetter’s Oasis warranty asks owners to retract in windy or rainy weather.
  • Do not leave it rolled up wet. Let it dry open on the next sunny afternoon, for example once the marine layer burns off. Sunbrella says to air dry its fabrics only.

Thinking about the whole awning rather than the fabric? Our guide to how long retractable awnings last helps you decide, and the SunSetter awnings page covers new installs.

SunSetter replacement fabric cheat sheet: identify your series, check the warranty, order by phone, swap in 7 steps with a helper, care tips for San Diego

FAQs

Can SunSetter awning fabric be replaced?

Yes. On SunSetter lateral arm awnings the fabric slides out of a slot in the roller bar and a slot in the front bar, so you can swap it without replacing the frame or arms. Order fabric that matches your model and width from SunSetter, and use two people for the swap.

How much is replacement SunSetter awning fabric?

SunSetter does not post fabric prices online, so call to get a price for your model and width. If it is under warranty it may be free or discounted. For a full job with labor, Angi’s 2025 data puts typical awning fabric replacement at $279 to $1,271, with an average of $769.

Can I replace the awning fabric myself?

Usually yes, if you have a helper, a ladder, a Phillips screwdriver and safety glasses. SunSetter’s steps take you from cranking the awning open to sliding the fabric out of both bars and rolling the new one on. The 900XT and 1000XT models use a harder method, and a bent bar or arm problem is a job for a pro.

Is SunSetter fabric covered by warranty?

Yes, for a time. Platinum fabrics carry a 10-year warranty: free replacement fabric in years 1 to 5, 50% off in years 6 to 8 and 25% off in years 9 and 10. SunSetter Series fabrics carry a 5-year prorated warranty. Wind damage and pooled water are not covered, and the 10-year warranty excludes labor.

How long does SunSetter awning fabric last in San Diego?

We could not find a published lifespan from SunSetter, but its warranties are a fair guide to what it expects: 10 years on Platinum fabrics and 5 years on SunSetter Series fabrics. Monthly rinsing, retracting in wind and rain, and drying the fabric before rolling it away all help it reach that here.

Rather not do it yourself? Call Awnings San Diego at (877) 391-0499 or request a quote online for SunSetter fabric replacement anywhere in San Diego County.

Sources (checked 16 Nov 2026): SunSetter fabrics and colors, SunSetter fabric comparison, SunSetter quality and fabric series, SunSetter 10-year warranty, SunSetter 5-year warranty, SunSetter: how to replace awning fabric, SunSetter support library, SunSetter Manual Awning specs, Angi awning fabric replacement cost, Sunbrella shade fabric cleaning, NOAA/NWS: Climate of San Diego.

Facebook
X
LinkedIn
WhatsApp

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

Scroll to Top
flower vector
star vector